| Age | Commit message (Collapse) | Author |
|---|
|
Only decode errors were counted previously. Keys are of the form
{Id, send, error}, where Id is:
{ApplicationId, CommandCode, Rbit} | unknown
The latter will be the case if not even a #diameter_header{} can be
constructed.
|
|
The error was detected as 5004 (DIAMETER_INVALID_AVP_VALUE) for
stringish Diameter types, in which case an AVP length that pointed past
the end of a message resulted in encode failure of the suggested
Failed-AVP.
Should have been fixed in commit 4ce2d3a6.
|
|
|
|
|
|
Invalid lengths come in two flavours: ones that correctly point at the
end of an AVP's payload but don't agree with its type, and ones that
point elsewhere. The former are relatively harmless but the latter leave
no way to recover AVP boundaries, which typically results in failure to
decode subsequent AVP's in the message in question.
In the case that AVP Length points past the end of the message, diameter
incorrectly regarded the error as 5009, INVALID_AVP_BITS: not right
since the error has nothing to do with AVP Flags. Ditto if the length
was less than 8, a minimal header length. Only in the remaining case was
the detected error 5014, INVALID_AVP_LENGTH. However, in this case it
slavishly followed RFC 3588 in suggesting the undecodable AVP as
Failed-AVP, thereby passing the woeful payload back to the sender to
have equal difficulty decoding. Now follow RFC 6733 and suggest an AVP
with a zero-filled payload.
|
|
Such a length caused decode of a message with valid (24-bit) length to
fail. Note that the error detected is wrong: it should be 5014
(INVALID_AVP_LENGTH), not 3009 (INVALID_AVP_BITS). This will be dealt
with by OTP-11007.
|
|
Instead, use whatever dictionary a transport has configured as
supporting application id 0. This is to support the updated RFC 6733
dictionaries (which bring with them updated records) and also to be able
to transparently support any changed semantics (eg. 5xxx in
answer-message).
|
|
An answer message with the E flag erroneously set the value to 0.
|
|
diameter_codec:sequence_numbers/1 is called on an already extracted pair
of sequence numbers in the case of failover.
|
|
* anders/diameter/capabilities_encode/OTP-10203:
Deal with the fact that capabilities config may be incomplete
|
|
A transport can be configured before its service so handle
insufficient configuration instead of crashing at CER/CEA encode.
|
|
The header is used when incrementing counters. Sending answers in
the list form was broken because of this.
|
|
If a peer fsm process exits then the exit reason is received by
the service process in a 'DOWN' message. If the reason is the one
generated by diameter_peer_fsm:close/2, which is called to signal
a non-transport failure before the completion of capabilities exchange
(eg. receiving an unsuccessful CEA), then an event is sent to any
subscribers.
Also, tweak capabilities_cb return values for more informative
event data.
|
|
Simpler, no duplication of similar makefiles and makes for
better dependencies. (Aka, recursive make considered harmful.)
|
